PDA

View Full Version : t-board


ethan82000
02-17-2006, 04:02 PM
hey everyone,
i just got my t-board and eyes today!! finally!! ok so my dad is drilling the holes for the eyes ond drilling and tapping the holes for the eye covers.(he works at a machine shop) i was wondering how to route the eye wires through the frame? i am ordering kila detents/eye covers. if anyone has the ability to take a picture of how they did theirs and the top view of the triggerframe i would greatly appreciate it. thanks. :) :D
Ethan
P.S. yes i know about otters site but i wanted better pictures of the top of the trigger frame where the eye wires run.

druid
02-17-2006, 05:14 PM
easy to picture in yer mind...

take a dremel and cut 2 chanels on the top left and top right of the frame...that are each 2mm deep, 2mm wide and run lateral on the frame...from the eyewires PAST the trigger to the top of where the capacitor is...

http://img.photobucket.com/albums/v388/druidsdecendant/Paintball/My%20mods%20and%20ideas/EYEWIRECHANELS.jpg