eggIII feed

[1shot1kill]

I want to cut down the feed neck of my eggIII because it is to long. Any suggestions on how to do this.

[interceptorMR2]

you got a bandsaw? :D I have an egg II, but i probably wouldnt use a chopsaw for something that small. unless you have mine, where it has a laser. but if you have a band saw or a smaller kind of saw that makes it easier, just make sure you cut it correctly on a drawn line or something and try to sand it down or something if thats possible.

[slim and shady]

For such a small task just use a hacksaw.

[bigred76]

A pipe-cutter works just as well too, such as the ones that they use on copper pipes for plumbing.

[SupaSnipa]

For such a small task just use a hacksaw.


A pipe-cutter works just as well too, such as the ones that they use on copper pipes for plumbing.

These both work perfectly

[DFSniper]

im just going to use a dremel, but not until AFTER i get a new feedneck! no sense in cutting it down then finding out your new feedneck is deeper than your old one...