PDA

View Full Version : MR3 stiffi?


artillerist90
01-05-2008, 10:53 PM
Does anybody know if a Stiffi barrel will make it down the MR3 shroud? If not, could it be easily ground down to fit (I imagine the base support would be the only section of the barrel that might not fit)?

DFSniper
01-05-2008, 11:10 PM
if anything, hollow out the shroud instead of risking damaging your barrel.

artillerist90
01-10-2008, 09:38 PM
Okay so I just got it in today. No, it doesn't fit. Took about 20 minutes to grind it down enough so that was good.

SpyderMan723
01-11-2008, 06:17 PM
what did you grind?!

artillerist90
01-11-2008, 07:36 PM
Toward the front of the barrel (that end that screws into the gun) there is a metal base that the carbon fiber barrel is put into so that it can thread into the marker. I ground about a milimeter of width off of this base so that it could fit. As you will notice, the silver area is obviously the part that I ground down. The carbon fiber was not touched.

http://i244.photobucket.com/albums/gg19/artillerist90/MR3/IMG_0038.jpg

http://i244.photobucket.com/albums/gg19/artillerist90/MR3/IMG_0039.jpg