PDA

View Full Version : Installing New Valve on E99


volleybiggs
12-09-2007, 01:53 PM
I am installing a new Valve on an E99. I was wondering if I had to take the trigger off to get too the bolt that held in place? Or does the bolt the holds the trigger on also hold the valve in place?
Also I guess the hole in the middle of the valve is what the screw goes into?

I added a bob long regulator to my spyder with polished internals and have it 400 psi and getting 280 fps with the velosity adjuster turned way out not all the way in. I am guessing a 38 degree valve and pin and maybe drilling out the va holes would get the pressure down even more.

The Pumper
12-09-2007, 02:05 PM
Yes..take off the trigger frame and it should be a brass flathead screw. Take that off and all the internals. Then push it out.

Kenny_McCormic
12-09-2007, 03:43 PM
Be careful removing/replacing it push it out with a piece of wood or plastic and dont scratch the inside of the body.