PDA

View Full Version : trigger bounce


JoeFab
11-24-2007, 05:48 AM
Hello - I recently picked up a spyder compact with a nasty case of trigger bounce. Help! What can I do to fix this? I totally disassembled, cleaned and oiled it but still no luck. TIA.

DFSniper
11-24-2007, 06:11 AM
trigger bounce as in more than one shot per pull?

spray and pray
11-24-2007, 10:35 AM
too sensitive. That or you need a new microswitc I think you would need a lighter one.

oldironmudder
11-24-2007, 11:03 AM
He/she doesnt need a new swtich. Just adjust the set screws on the trigger & tweak the spring a little. Pull on it a little & put it back in will make it stiffer & harder to bounce.

DFSniper
11-29-2007, 11:08 AM
uh, guys, not to rain on your parades or anything, but youre both wrong. because compacts dont have eframes...

oldironmudder
11-29-2007, 04:20 PM
What if one was swapped onto it?? ;)

DFSniper
11-29-2007, 05:02 PM
then it wouldnt be under semi-autos most likely.

this just came to me: its a compact, so its seen some use. ill bet that the sear is rounded off and thats why its not catching.

JoeFab
11-30-2007, 09:51 AM
Thanks for the replies. It has a standard trigger and I believe that I need a new sear and trigger. Where can I get these parts? TIA.

DFSniper
11-30-2007, 01:10 PM
b/s/t is about the only place. if its not too bad, you can always sand it straight again.

JoeFab
12-05-2007, 08:48 AM
Pardon my ignorance, but what is b/s/t?

DFSniper
12-05-2007, 10:57 AM
the buy/sell/trade section.

JoeFab
12-06-2007, 04:53 PM
ahh, thanks!