View Full Version : Question about the bolt

02-08-2006, 08:21 PM
Hi all..,

i was reading that one of the modifications is to take out the Venturi, in the most of the pages over the net, they explain the procedure to take the Venturi thing, heating it, and then using the dremel to smoth the bolt seat.., but? it will work on a delrin bolt? i mean? it will not melt??? can i use the same procedure? or there is something new?? and exist another page where i can find new information, cause all of those show info about older markers (i know, all the spyder are almost the same) but the new ones have new materials, and they are a little different..,

Thanks in advance..


02-08-2006, 08:49 PM
If you have an Delrin ACS bolt there isn't a venturi in it. However if you do have a Delrin bolt and there is a venturi, no you cannot heat it it will melt.

02-10-2006, 04:57 PM
yeah, there should be no venturi in the first place in the derlin bolt ... but if there is you could always try to just twist it out ... never heat it up though .. it will melt

02-12-2006, 07:09 PM
Thanks Guys :)

02-12-2006, 09:49 PM
yep, no problem we're always here to help