PDA

View Full Version : Eframe specs


oldironmudder
10-16-2007, 06:57 PM
I need some help from my fellow KUSA Krew. The noid that is used for Eframes, I need the stroke of it. Inchs or mm will do. I need it as close to dead on balls as possible.

Thanks

codymm1014
10-17-2007, 03:06 AM
You need the space in between the actual noid body and the flat disk? I'll see what I can do...

oldironmudder
10-17-2007, 02:41 PM
When it is at rest to the end of cycle.

vwjimmy
10-17-2007, 04:03 PM
Do you want these measurements within the confines of the frame? The piston and plate is not sprung in either direction, and it is not restricted in its travel....so the return is wherever the sear pushes it back to, and the forward travel is set by the sear and the frame casting.
I'll get my mic out!

Oscum Guy
10-17-2007, 04:13 PM
ask oldironmudder, i think i told him once.

oh wait you are oldironmudder :p

oldironmudder
10-17-2007, 04:35 PM
oscum- shut up, Ive slept since then.

Jimmy- I guess the gap between the body & the flapper would be the the stroke.

codymm1014
10-17-2007, 05:30 PM
ill try and measure mine when I gut my eframe apart.

oldironmudder
10-17-2007, 05:39 PM
thanks