PDA

View Full Version : High flowing valve


Alien
09-24-2007, 07:35 AM
Hi, I would like to know what a high flowing valve add in performance to the marker and where can we get a good one for the MR2

shunut
09-24-2007, 09:01 AM
A high flow valve will help lower your operating pressure and increase your air efficiency. My favorite valve is the Maddmann Rocket Valve. Initially it takes a little bit more than other valves to setup but I think its worth it. Remember though, to get the benefits of the valve you will also need a regulator and to get the FULL benefits, you'll need to upgrade much more, VA, bolt, striker, springs. Finally, the Rocket valve is made to operate at 400psi and below, so if you don't plan on purchasing a regulator and probably upgrade a couple other parts I wouldn't get the Rocket valve. I'd probably go with a NDZ valve or another similar valve that can handle the increased pressure.

Alien
09-24-2007, 09:33 AM
I currently have the palmer male stabilizer , alamo city with 2 oring and that it.. And what is the VA?

shunut
09-24-2007, 10:28 AM
I forgot that the MR series does not have a VA. The VA or Vertical Adapter, is the front block on most Spyders.

Alien
09-24-2007, 02:17 PM
With the valve and my palmer stabilizer do I need a spring kit?

Kenny_McCormic
09-24-2007, 02:35 PM
yes but only for the striker springs the rocket valve has its own built in spring.

Alien
09-24-2007, 02:39 PM
Ok so with this setup my gun should be "a little bit " LP and shoot more balls per tank

Alien
09-25-2007, 03:10 PM
I have another question but this not concern the subject . Does my palmer male stabilizer could fit where we usually ,put an expansion chamber

oldironmudder
09-25-2007, 03:31 PM
Yes, a male palmer will screw right in where your X-chamber is.