View Full Version : Mr2 trigger mod on you tube?
08-19-2007, 07:37 PM
Hello all, new to the site, alot of great info. saw a mr2 trigger mod on you tube and it stated that it was posted here?
08-19-2007, 07:39 PM
What does the mod do?
08-19-2007, 07:46 PM
well the narrator says it ups the rate of fire, which you can def. hear. and makes it like hair trigger pull. I just have a stock trigger and its hard to walk and the guy on there does it no problem. but the video actually says that the mod is posted in spyder forums ?
08-19-2007, 07:49 PM
www.youtube.com and type in "mr2 trigger mod"
08-19-2007, 08:03 PM
Looks like the trigger was adjusted so theres very little slack. He may have modded the switch it self but cant tell.
08-20-2007, 06:57 AM
There are two mods you can do on spyder trigger frames:
1 - Reactive Mod
2 - Sensitive trigger Mod
1 - Reactive trigger Mod
Basically you interconnect the two end pins of the micro switch like so:
XX = Switch
--- = Pin to use
2 - Sensitive Trigger Mod
08-20-2007, 08:03 AM
whats the differance between the two mods? and would you recommend either one over the other?
08-20-2007, 08:09 AM
I highly recommend the Sensitive trigger Mod but with a special attention no to let the trigger press too deep on the switch or you'll ruin it.
08-20-2007, 10:14 AM
Thanks for the great info, do you have an mr2? if so what kinda set up/mods do you have for it that you would recommend?
08-20-2007, 03:43 PM
I got an MR2 an you can take a look at it on the MR2 pic thread.
The only mod I actually did was the Sensitive Trigger one with great results, other than that I only installed a CP reg on it which you can actually use under the plastic fore-grip if you actually like it.
08-21-2007, 06:28 AM
this is not in the subject but I was curious if it's possible to make the MR2 frame mechanic with some part of the MR1 mechanical frame
08-21-2007, 06:31 AM
I think you only have to get the full MR1 frame an that's it but I'm not sure.
08-22-2007, 11:58 AM
The screws hole are not at the same place it wouldn't fit.. but is it possible to exchange part from the mr1 frame to my mr2 frame to make it mechanic ?
08-23-2007, 10:19 PM
Just finished the trigger mod, very nice pull and performance. Great job Viper!