PDA

View Full Version : oring help!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!


stefano_cercone
07-27-2007, 04:57 PM
help please i want to know if the #11 oring thats near beneth the ASA is a complete O or is cutted U

i have a big leak and only used my gun once!!!!! please !!!!!!!!!!

does oring come in stabdard sizes cause there are # 11 so i tought it was like a thread number im correct?????


if so can i bought the # 11 in a ACE store or hardware house ???? is same material??

thanx!!!!!!

Critical
07-27-2007, 05:10 PM
If Kingman is listing #011 as being the same as standard sizes, a -011 oring is 5/16 inside diameter x 7/16 outside diameter x 1/16 width. I didn't see that size on the Ace Hardware site, but you might get lucky in the store.

Sandman_Bravo
07-27-2007, 05:21 PM
I'm not sure what o-ring you are talking about but there are no "U" shaped o-rings. Find it here on page 3:
http://www.spyder.tv/section/support/manuals/spyder_pilot.pdf
Then go buy one at a hardware or auto supply shop. Here's another helpful link:
http://www.mcmaster.com/
Good luck.

Critical
07-27-2007, 05:27 PM
mcmaster has great prices for Nitrile ($1.87 for 100), but I'm not impressed with their prices for polyurethane ($7.70 for 10). I got 100 for $15 online.

stefano_cercone
07-27-2007, 08:30 PM
from what material is made the one i need the exact part is 37C

Critical
07-28-2007, 04:22 AM
You could use either Nitrile (also called Buna-N) or Polyurethane for that location. Nitrile is much cheaper, if it was me, I'd go with that.