PDA

View Full Version : Working on a spyder shotgun, questions.


TimVanNormal
07-24-2007, 04:53 PM
http://i36.photobucket.com/albums/e39/TimVanNormal/bolt.jpg
Would there be any defects in the performance of the bolt if I were to cut from halfway through the skinnier portion back to the end? I need to utilize the smallest back half of the top possible for my pump project, so I do not need the pin hole area, or anything.

Critical
07-24-2007, 07:13 PM
I'd take out the bolt and line it up with where it would be in the cocked position. Anything behind where the last o-ring is, can be cut.

TimVanNormal
07-28-2007, 08:45 PM
I ended up cutting it, and I bit more.
I'm almost positive it works, just need an asa (removed the forgrip and asa ect.
I'l post newer pictures, and updates in a bit.

TimVanNormal
07-29-2007, 08:03 PM
new question.

bamf-hacker
07-30-2007, 07:24 AM
Um ok, what is the new question?

Hossy
07-30-2007, 07:36 AM
Um ok, what is the new question?

I believe he edited his first post

TimVanNormal
07-31-2007, 02:58 PM
yep, I did.

paintballkid0206
08-01-2007, 09:58 AM
waiting apon pics of your finished marker. what was the base marker?

Critical
08-01-2007, 10:24 AM
Does the pin hole go through to connect to the striker? That would be my only concern, how to connect the bolt to the striker, otherwise, the 2 other o-rings should be enough to seal it fine.

TimVanNormal
08-02-2007, 05:28 PM
waiting apon pics of your finished marker. what was the base marker?
it is a vl triad..
Pretty much a spyder victor.
Thanks for the help to all others.