PDA

View Full Version : New VS1 design


Elfmaze
06-22-2007, 08:06 AM
I am looking to get a vs2 to replace my old tl+ body in my rig. I was set on a VS2 but when i went to look at prices i saw that they had released a VS1 that is CO2 compatible. Honestly i reallydon't want to have to get hpa where i live, and i have a bulk co2 tank.

Now what did they do to the VS1 to get it to shoot CO2? Is it still the same design? low pressure?

clickclicksplat
06-22-2007, 09:35 AM
I believe the VS1 doesn't have the balance valve, so no, it's not low pressure.

pb34
06-22-2007, 11:09 AM
Yup, there is no balance valve in the VS1. Also it just has a regular ASA as opposed to a regulator/ASA combo.

Elfmaze
06-22-2007, 03:22 PM
Ewww so bsically tosses the whole point, besides some lighter internals. VS2 it is

Kenny_McCormic
06-22-2007, 03:50 PM
you can run co2 in the vs2 if you swap the asa/reg with a palmer female stabalizer.

Elfmaze
06-22-2007, 10:16 PM
I have a palmer male. i know a trinity front will make it fit, but will a sandard palmer male reg work down in that low pressure?

118917
06-22-2007, 10:48 PM
it should
it operates from o to 600 psi
(I think)