View Full Version : double shots with single fire
06-10-2007, 06:10 PM
i was shooting my gun today and almost ecerytime i shoot it shoots twice with one pull on the trigger i have the 06 electra w/eye and it would like go poppop but only 25 percent of the time
06-10-2007, 06:19 PM
pressure too high? velocity between 285 and 300? maybe you adjusted the rocking trigger to have a very light response.
06-10-2007, 06:20 PM
no the pressure isnt high it runs at around 500 to 700 PSI maybe the velocity idk
06-10-2007, 06:25 PM
what were you shooting at the chrono? Have you messed with the trigger at all? I bet anything it's the trigger if you messed with it
06-10-2007, 06:28 PM
yea i did but i dont think that matters but your the spert expert lol so ill try ajusting it ******ds
06-10-2007, 06:29 PM
that was a bad word all i put was ill try adjusting it out wards umm idk
06-10-2007, 06:47 PM
only a suggestion...do what you wish
06-10-2007, 07:19 PM
Check your sear. if it is chipped or rounded then that is your problem. Your problem might be bounce also.
06-11-2007, 06:22 AM
sounds like bounce to me too...
06-11-2007, 11:18 AM
whats bounce and a Sear ?? sorry lol
06-11-2007, 11:21 AM
Adjust the trigger out. Sear is the thing inside the bottom tube that moves when you press the trigger.
06-11-2007, 12:07 PM
can somebody help me out adjusting the screws on my trigger because its the rocking trigger i just need help adjusting how many turns
06-12-2007, 09:51 AM
Are you pushing the trigger down all the way?
Cause if you push it down halfway it will shoot really fast...
06-17-2007, 05:33 PM
Could it be bad detents?
06-18-2007, 01:29 AM
It really sounds like bounce to me, did you adjust the travel screws on your rocking trigger, if you screwed them in towards the grip of the gun that can cause immense bounce, if you did that, try unscrewing them and see what happens because it sounds like you have the same problem as i did where i adjusted the travel on my trigger, but what i did was let the trigger only just activate the microswitch, and that turned my marker into a jackhammer.!!
So have a look and see if its that, let us know :waytogo:
06-20-2007, 10:41 AM
whats a bullet volumizer???
06-20-2007, 10:44 AM
also how can i get a picture as my profile picture thing
The link below will take you to a thread that tells you how.
How to Put Up an Avatar (http://www.spyder.tv/forums/showthread.php?t=48)
07-13-2007, 10:13 AM
what is happening is you probity tried to adjust the trigger which is what most ppl do.
you adjusted it by mistake so that when you put one trigger then let go then ,.. the other one hits the switch and shoots.
adjust ur trigger
its all about the bounce
07-13-2007, 02:41 PM
Sounds like the detent to me. My IMAGINE was doing the same during high rates of fire.
Installed a MAGNETIC detent from "Kila Products", problem cured :D
10-21-2007, 03:57 PM
like mechanical bounce
like the kick is making it shoot
and the sear is the thing that holds the bolt back and clicks when u cock it
and is attached to the solenoid(clicky cylinder)
there all right
a worn sear, or mech. bounce
07-11-2008, 05:53 AM
Well when I first got my spyder pilot 05 I had the same problem. Turned out to be trigger bounce. Since no one really explianed it I guess I will. Trigger bounce is when you pull the trigger once and the recoil of the gun causes the gun to jerk and hit your finger again and can sometimes can't even be noticed. Try pulling the trigger with one finger while not having any thing else (ie. a finger) in the trigger guard. As soon as you pull the trigger once quickly pull out your finger and keep doing it to see if the problem still happens. This will eliminate the problem of the trigger hitting you and making the gun go off again unintentionally. Good luck!!!
spray and pray
07-11-2008, 04:47 PM
actually it would be he has his trigger set too sensitive and the kick causes the trigger to fire again before it fully returns to the forward position. Make the trigger less sensitive.