PDA

View Full Version : havin lp problems


weitjosh
05-28-2007, 07:23 PM
ok, i have converted my marker to lp, as u can tell by the sig, but just here recently, my marker has started burpin and not recockin. wut is the deal?? any suggestions are appreciated!!!

Hossy
05-28-2007, 07:26 PM
lubed the orings?
have enough air going into the gun?

weitjosh
05-28-2007, 07:33 PM
i clean it all the time and this was with multiple full tanks.

Hob Hayward
05-28-2007, 08:02 PM
Burping at any pressure, or just at lower pressures? Do you have a gauge in the 32* V/A or a gauge on the reg so that you know what pressure its working at?

Pwgsx
05-28-2007, 08:13 PM
increase the pressure on your reg. or get a spring kit and fiddle around with different combinations.

weitjosh
05-29-2007, 12:30 PM
no gauges at all no. i have the reg set all the way up, its rated at 0-500 psi so im thinkin its running somewhere around 500. it only burps wehn i have the reg on, i put the stock fore-grip back on and it fired just fine. im thinkin i got a bum reg, would rebuilding the reg help with that you think??

pb34
05-29-2007, 12:35 PM
Try disassembling(sp?) the reg and lubing the inside of the reg with dow 33. Or you could just try shooting some oil through the gun but lubing the reg would be your best bet.

Hob Hayward
05-29-2007, 01:31 PM
Yeah, try getting some lube in the reg.

Are you sure that you've turned the pressure all te way up and not all the way down? (Different regs adjust differently, some screw in to raise pressure, others screw out.)

Pwgsx
05-29-2007, 03:48 PM
what VA do you have?? It might not be high flowing.......

Sandman_Bravo
05-29-2007, 05:49 PM
no gauges at all no. i have the reg set all the way up, its rated at 0-500 psi so im thinkin its running somewhere around 500. it only burps wehn i have the reg on, i put the stock fore-grip back on and it fired just fine. im thinkin i got a bum reg, would rebuilding the reg help with that you think??

Are you sure it's all the way up not all the way down? Some regs you screw in to raise psi; some to lower. Without a gauge on the VA it's difficult to trouble-shoot.

weitjosh
05-29-2007, 09:20 PM
found my problem, i took apart the reg and the long (for lack of better word) "bolt" that moves when you set the diff pressure, wasnt moving. it was basically all the way closed. reset the set screw on it and now it works perfectly. thx for the help guys!!!