PDA

View Full Version : Broken Trigger Frame


boogieman69
05-28-2007, 03:32 AM
I am trying to salvage a broken trigger frame. I would really like to be able to use this frame because it is a single trigger style that will work perfect for my pump project. Below is a pic of where this frame is broken (not the broken one). Anyone have any ideas? I am floating a few around but wondered if anyone else had something better. Thanks all.
http://i44.photobucket.com/albums/f2/fatbastard69/broken.jpg

NeedForSpeed
05-28-2007, 03:35 AM
super apoxy? Some of the stuff out there is supposed to be able to withstand lots and lots of pressure. I have some on one my bass drum beaters for drums and it holds up nicely untill i buy a new beater.


Is this just a single mech frame? I could send one to you for $5 if you want or however much the shipping costs depending on where you live.

EDIT: I just realized you want single-trigger so scratch that^

boogieman69
05-28-2007, 03:40 AM
Its a single trigger mech frame that I'm trying to salvage. Theres a pic below.

http://i44.photobucket.com/albums/f2/fatbastard69/singletrigger.jpg

Nenkitsune
05-28-2007, 08:07 AM
i dunno. i actually only have the front frame screw holding my frame on atm. it holds up really well. but it's also metal. i'd say your best bet would be some sort of epoxy or glue. maybe gorrila glue?

Kenny_McCormic
05-28-2007, 08:23 AM
dremal a channel across the break and fill it in with jbweld. be sure to give it 24 hours to dry

Hob Hayward
05-31-2007, 11:15 AM
Pin it.

Drill two small holes (paper clip diameter) in both halves of the frame (line-ing up EXACTLY) and use two cut pieces of a large paper clip to put in the holes, epoxy it all together, and it should be much stronger.