PDA

View Full Version : remote coil


shark
05-24-2007, 05:43 PM
i have one of the remotes from trinity paintball with slide check valve. after i put on the tank and attached it to the gun, i try to push the valve forward to let air from the hose into the gun, it leaks like crazy. I just bought this and haven't played or done anything with it. Is it something i am doing wrong or is it a bad seal or what? any help would be appreciated
thanks

Team Ramrod
05-24-2007, 05:48 PM
Check your o-rings on the tank. It may not be sealing correctly when the pin is depressed and thus venting the air around the threads. Also, if that looks fine, try adding another o-ring into the asa before you screw in your asa, this will also help seal the tank, 'cause sometimes the threads and o-ring just don't get the tank far enough in.

edit: i may have mis-read your question, looks like your having trouble with the slide check, not the asa. Hmm, try a bit of oil into the slide check, maybe the o-ring got a little dried up and isn't sealing correctly. if you can, try replacing the o-ring in the slide check.

shark
05-24-2007, 05:49 PM
maybe, but if i put the tank directly onto the gun it doesn't leak.

thanks, i will try that

i just tried oiling the o-ring on the slide check. it still leaks. i definitly know it is coming from the sealing right in front of the slide check or the o-ring on it. i don't have any o-rings that size. it didn't come with any and the ones that came with my mr1 are too big.

does it matter if i am running it on co2 or compressed air. i was running it on compressed air and it might just be to high of pressure

USE THE EDIT FUNCTION NEXT TIME. DO NOT, I REPEAT....DO NOT MAKE 4 POSTS IN A ROW AGAIN. READ THE POSTING RULES BEFORE YOU POST AGAIN :rolleyes:
sorry:foreheadslap:

Team Ramrod
05-25-2007, 02:59 PM
Compressed air or CO2 will not make a difference. CO2 could actually give you higher output pressures, so changing air systems will not help. Id give your pro-shop a call or Trinity depending how old the remote is and try finding some o-rings and see if that will do the trick.

shark
05-25-2007, 04:40 PM
i changed o-rings and resealed a thread and now it works perfect. thanks for the o-ring idea!

Team Ramrod
05-25-2007, 05:29 PM
No problem, it's what were here for.