PDA

View Full Version : bolt problem


oscar
05-20-2007, 05:54 AM
i gun have 05 electra acs, i can not figure how to get the top cocking bolt out
the screw in the back is stripped i guess i bought the gun new and could not get it out i have taking the whole rest of the gun apart except for this and the striker of course, can not get one out with out the other,help?????

Kenny_McCormic
05-20-2007, 08:50 AM
you pull out the cocking pin from there im pretty sure the bolt just slides out

oscar
05-21-2007, 04:31 AM
no it does not pull out the set screw in the back holds it in to far that is the way i got it new now the head is messed trying to get out

kidonfire
05-21-2007, 08:48 AM
There is a screw in the back of the bolt. It's hard but loosen it a little to see if that helps.

Kenny_McCormic
05-21-2007, 12:04 PM
yeah its loctited needs heat hold a lit match up to it as long as you can then try unscrewing it

pb34
05-21-2007, 01:24 PM
Try using a pair of pliers to get the top cocking pin out. You might be able to get it out that way. Otherwise you'll have to try to loosen the screw on the back of the bolt.

xSoulsx
05-21-2007, 01:56 PM
I have the same problem witht he bolt thing it comes out like half way but then its just really hard to get out....

pb34
05-21-2007, 02:12 PM
You have taken the cocking knob out right? Well if its coming halfway out you need to turn on the trigger frame and shoot it a couple times while pulling it out. The reason it won't come out is because the sear is sticking up and preventing it from coming out. Pulling the trigger pulls the sear down. So while pulling the trigger pull out the bolt at the same time.

xSoulsx
05-21-2007, 03:33 PM
Oh, the white bolt? Yea I know you have to shoot to get it out...I thought he ment the cocking PIN...The one you need to use to cock the bolt... Hehe OPPS:D :D :D

pb34
05-21-2007, 03:49 PM
Oh he is talking about the cocking pin, I thought you were talking about the actual bolt.

oscar
05-22-2007, 04:54 AM
I tried using plyers to pry the pin out but no luck i will try the match trick later on the screw to see if that works but the outside of the bolt is plastic so will have to use small amount of heat if it is lock tite
thanks

Nenkitsune
05-22-2007, 05:09 AM
well since it's all delrin it should be fairly easy as long as you ahve the right sized screw driver.

oscar
05-22-2007, 05:21 AM
thats the problem the screw in the back of the bolt is stuck yes i used the right screw driver but now the head is messed up a little

oscar
05-25-2007, 02:12 PM
solution i drilled out the rear screw got the bolt out

Ace24
05-25-2007, 08:57 PM
lmao time for a new bolt.

Kenny_McCormic
05-25-2007, 09:03 PM
just tap it for a bigger bolt. i dont get why kingman hasnt come up with some sort of ball detent system to hold the pin in.