PDA

View Full Version : Removing the trigger


Charfizcool
05-03-2007, 05:09 PM
I can't seem to get the pin that holds the trigger to budge. What are some easy ways to get that pin out? I've tried using a nail and an old allen wrench; results=bent allen wrench, and nail keeps sliding around. BTW this a ACS grip frame (not sure if that matters). Also I've been hitting the pin on the smooth side (I'm pretty sure thats the right side to hit it on).

Nenkitsune
05-03-2007, 05:12 PM
the smooth side is what you want to hit. try cutting the tip off the nail.
and if at first you don't succeed, get a bigger hammer

08Lud08
05-03-2007, 05:44 PM
It takes hard hits, don't be scared to hit it a little bit harder. also make sure that you find a way to raise the frame so the pin can actually come out.

pb34
05-03-2007, 05:47 PM
Yeah, the first time you take it out it really takes a good couple of whacks!

Charfizcool
05-03-2007, 05:52 PM
Thx guys first I dremeled down the tip of a nail then set the grip frame on a bunched up towel and gave the pin a hard hit and it popped out.