PDA

View Full Version : steel ball barring inside vs3?


kc74
04-30-2007, 08:03 AM
does anyone know where thes ball barring goes or is it a factory mess up?:confused:

kayfabe1204
04-30-2007, 08:27 AM
I thought the same thing at first, but then I realized it came out of the ACS bolt. Its what holds in the pin. Take the set screw out of the back of the bolt, and put the bearing, and set screw back in. Last put your pin in, and tighten the set screw till the pin wont come out. Let me know if you have any more questions.

Mormon
04-30-2007, 02:55 PM
The pin comes out too easy just don't pull to hard and it won't go pass the ball bearing.

DRAGON
04-30-2007, 03:21 PM
There's a set screw, spring and bearing. You adjust the tension on the pin with the set screw. Read the manual! Page 14 says to lift up on the pin, not pull it out -

kc74
04-30-2007, 03:21 PM
ty for the info and fast reply.... i now feel realy dumb lol

marouca1
08-07-2007, 08:44 PM
my vs3 ball bearing wont come out it stuck in the engraving thing on the pin
how can i get it out

TXTeague
08-10-2007, 05:24 AM
my vs3 ball bearing wont come out it stuck in the engraving thing on the pin
how can i get it out

Why would you want to take it out? Try tightening the set-screw on the back of the bolt and then remove the pin and the ball bearing will pop out on its own. If you were meaning the pin seems frozen/stuck in the bolt and will not move, loosen the set-screw to allow the pin to move easier.