View Full Version : VS3 Feed Neck?

04-16-2007, 02:55 AM
I took my feed neck off to clean it and the c-clip came off! i tried to put it on and finally got it, but it don't seem the same?? I remember when it was tight i could put my hopper on and the hopper would be loose.. and a friend screwed it counter clock wise to tightin' the hopper on. i forgot how once the c-clip came off i only used the gun one time.. So am i right clock wise to put it on the gun and counter clock wise to tightin' it to the hopper???? now it go's one way but the whole feed neck moves... i wanted to get a different feed neck but not sure what fits the threads, i read that an "ION" would fit can anyone help???? thanx

04-16-2007, 09:58 PM
Clockwise to put it on the gun, clockwise to tighten the hopper. I bet you dont have the c clip on correctly. Counter clockwise to loosen and take it off. Try it again, its hard to explain how it goes on in words.

04-17-2007, 01:13 AM
yea!!..... i'm sorry if i confused anyone!!