View Full Version : halfbacking
bracer028
04-01-2007, 10:38 AM
after i saw it, what do i use to sand it?
wouldn't it be very difficult to get the edges and the angles?
mogar158
04-01-2007, 10:47 AM
its not to hard after you cut it use a file to neaten it up and also use the file to get angles in the half back
bracer028
04-01-2007, 11:07 AM
any way to get a shorter cocking stem?
the aka lightning bolt cocking rod is like 4 inches long and sticks out from the back.
is there a way to cut that cocking rod short enough where you could only cock it with a half back?
what would i use to replace the cocking rod? any ideas? like a metal thumb holder of some sort?
http://www.p8ntball.be/prodimages/NPS/Alias-SilverwithRedSleeve.jpg
you see that timmy with the cocking nob. is it possible to make it come from the back? where do i get one of those.